Tongue and groove paneling is a popular way of adding character and beauty to a space. You have many options for how to install this type paneling. However, all of them require accurate measuring and cutting. Most panels are attached to furring strips which run vertically along the wall. This is the most popular method. Another way is to install diagonally using a 45 degree angle cut at both ends to form the long groove side.
Installation Steps
You must remove all hooks, outlets and nails from walls before hanging wood planks. You will also need sand to remove any protrusions. You can use a power drill or large sections of sandpaper and an extension table to accomplish this task.
Find out if your tongue-and-groove paneling is nailed or screwed to drywall.
A pry bar can be placed near the corner of the wall where the tongue and groove panels meet. With your hammer tap the prybar into seams where the two wall meet. You will need to remove the panel from the wall if it isn't nailed to the drywall using a prybar and pliers.
Find out if your tongue-and-groove wall panels are nailed on or glued.
Once you're certain that your paneling has been properly nailed to drywall and are satisfied with that, start removing any trim attached to the wall. Ideally, you'll be able to reuse the trim, so try your best not to damage it.
If you cannot reuse the trim, you will need to purchase new wood panels. Take the measurement of the wall to be covered and divide it by four. This will give you the number of sheets that are 4' x 8. If you have walls greater than 8 feet tall, subtract one panel for each door and one panel for each window.
Marking a Straight Edge on Drywall
Make sure your wood paneling runs evenly along the drywall surface. Run a straight edge down the wall side-to-side to make sure it is. Look for any areas where the drywall protrudes above or below the wood paneling, especially at corners and over door and window frames. If the drywall bulges it will cause your paneling not to lay flat or stick out too much.
Dust Mask to Sand Drywall
You should sand any areas where the drywall is protruding when installing tongue and groove panels over drywall. This will make it easier and more even to install your paneling.
Finishing with Wood Puffin
After you have sanded down the wall, apply a coat with wood putty over the paneling and walls to seal the joints. It is possible to stain the paneling with wood stain, which gives it a natural look. However this is more labor intensive than applying a coat.
Attaching Paneling to Drywall
You will need a nail set that has rounded heads to attach wood paneling and drywall. These fasteners can be purchased at most hardware shops and cost approximately $4 for a pack of 16-penny common nail. These fasteners are compatible with any kind of wood including plywood and drywall. But if you need to install thicker boards than that, use construction staples instead or pneumatic fasteners.
FAQ
What order should renovations of the home be performed?
When renovating your home, the first thing to do is decide where everything should go. If you are looking to sell your property soon, you need to plan how you will present your home to buyers. Next, think about how you want your living space, including the kitchen, bathroom and living room. After you have selected the rooms you wish to renovate you can begin searching for contractors who specialize. After you have hired a contractor to work on your project, it is time to get started.
How can I avoid being taken advantage of when I renovate my house?
The best way to avoid being ripped off is to know what you are paying for. Before signing any contract, read through the fine print carefully. Don't sign any contracts that aren't complete. Always request copies of signed contracts.
Do I need to hire an architect?
It may be simpler to hire someone to help you renovate your home. If you're looking to purchase a home, an architect or builder can help you achieve your goals.
What room do I need to remodel first?
The heart and soul of any home is the kitchen. It's where you spend most of your time eating, cooking, entertaining, and relaxing. If you're looking to make your kitchen more functional, attractive and beautiful, this is the place for you!
It is also an important component of any home. It provides comfort and privacy while you take care of everyday tasks, such as bathing, brushing teeth, shaving, and getting ready for bed. If you want to improve the functionality and appearance of these rooms, consider adding storage space, installing a shower instead of a tub, and replacing old fixtures with modern ones.
Statistics
- According to the National Association of the Remodeling Industry's 2019 remodeling impact report , realtors estimate that homeowners can recover 59% of the cost of a complete kitchen renovation if they sell their home. (bhg.com)
- They'll usually lend up to 90% of your home's "as-completed" value, but no more than $424,100 in most locales or $636,150 in high-cost areas. (kiplinger.com)
- A final payment of, say, 5% to 10% will be due when the space is livable and usable (your contract probably will say "substantial completion"). (kiplinger.com)
- It is advisable, however, to have a contingency of 10–20 per cent to allow for the unexpected expenses that can arise when renovating older homes. (realhomes.com)
- Most lenders will lend you up to 75% or 80% of the appraised value of your home, but some will go higher. (kiplinger.com)
External Links
How To
How much money should I spend restoring my old house?
Cost of renovating your house will depend on the number of rooms you want to upgrade, what type of renovations are planned, where you live, as well as whether you hire professional help. Depending upon the size of the renovation, the average cost ranges between $10,000 and $50,000.
If you plan to sell your house after renovations, the value of the home will likely be lower than its market value. This is because you do not take into consideration the costs for repairs, upgrades, or improvements. You could lose money if the home is not maintained in a good condition before selling. If you put enough effort into making your home look great, it will increase the price you receive when you sell it.
To help you decide which projects to undertake first, consider these factors:
-
Your budget. If you have a limited budget, start small. Start small. For instance, you could tackle one room at once, such as replacing flooring or painting walls. For major renovations, you can either hire a contractor who specializes on kitchen remodeling or save money.
-
Your priorities. You decide what you are going to do with your home. If you choose to tackle only one issue, keep in mind that minor issues can add up quickly. If your roof leaks when it rains, it might be necessary to have it replaced sooner than you think.
-
Your timeline. If you're thinking about buying another property soon, you might want to prioritize those projects that won't affect the resale value of your current home. If you're considering buying a property next year and want hardwood floors installed or new bathroom fixtures, then you won't want them to be done right away. Instead, you might wait until you move out of your existing home to make those updates.
-
Your skills. Find someone to help you if you don't have the necessary skills. You might hire a cabinet maker if you don't have the skills to build custom cabinets.