The seam at the end of the tub's flange will meet the backerboard on the back wall of a bathtub is common. This is an area where caulk is usually applied to seal the seam. But, there are some areas that cannot be sealed and might need to repaired. This area should be sealed and repaired by following the appropriate procedures.
Check that the tub's back wall has a level surface. The old tub surround must be removed before you begin installing the new one. This can be done with a pry bar, or a Hammer. Also, be sure to wear protective gear.
A tub surround can be installed over concrete, tile or wood depending on your needs. You can purchase these surrounds in a variety of styles and colors. Plastic panels or acrylic are the most popular. Each type has its specific installation instructions. Some kits only have a back panel. Others include two. Consider purchasing a one-piece surround to keep your costs down.
After you have removed the old surround, remove the corner panels. You will then need to measure your new surround to determine its dimension. The adhesive must be the right type to stick well. Adhesive will need to be applied to more than one section at a time, so allow plenty of time for it to dry.
Before you apply the adhesive, mark your walls on the left and right and the top and bottom edges of the surround. This will serve as a visual reference point to help you apply the adhesive. Make sure you cut the adhesive lines precisely. You can make the lines stand out by using masking tape.
Next, place the back piece of the surround against the wall and adjust the back to be flush. Make sure the entire back is flat against the surface of the drywall. If the back piece is not level, you'll need to add some extra adhesive to the gap. After you have applied the adhesive, allow it to dry for at minimum 24 hours.
You can now put the tub surround's backwall in place. This is often the easiest step. However, it's a good idea that a friend holds it in place to help it stay steady. Alternatively, you can set a level across the surface and use it to guide the installation.
Afterwards, you'll want to attach the flanges to the studs. Fasteners should not be driven through predrilled holes with a large diameter. Two to four nailers are recommended for added support. They should be attached directly to wall framing, but not to the drywall.
You'll also need to apply the appropriate vapor barrier before you begin tiling. A vapor barrier is thick plastic sheeting that protects the wall from moisture. You will also need primer and paint. There are many types of glue available. For more information, please refer to the manufacturer's instructions.
FAQ
What should I do first in a house renovation?
Cleaning out clutter inside and out is the first step to fixing up a house. Next, clean out any moldy areas. Next, clean the exterior surfaces and paint.
Can I rent a dumpster?
After completing a home renovation, you can rent an dumpster. Renting a dumpster to dispose of your trash is a great option.
How do you sell your house quickly and without the need to pay realtor fees
It is important to start looking for buyers as soon as possible if you wish to quickly sell your home. You should be open to accepting any price offered by the buyer. You will likely lose some buyers if you hold off too long.
Statistics
- According to the National Association of the Remodeling Industry's 2019 remodeling impact report , realtors estimate that homeowners can recover 59% of the cost of a complete kitchen renovation if they sell their home. (bhg.com)
- Rather, allot 10% to 15% for a contingency fund to pay for unexpected construction issues. (kiplinger.com)
- They'll usually lend up to 90% of your home's "as-completed" value, but no more than $424,100 in most locales or $636,150 in high-cost areas. (kiplinger.com)
- On jumbo loans of more than $636,150, you'll be able to borrow up to 80% of the home's completed value. (kiplinger.com)
- Most lenders will lend you up to 75% or 80% of the appraised value of your home, but some will go higher. (kiplinger.com)
External Links
How To
How to renovate an older house
Before you start, it is essential that you decide which type of renovation project to undertake. This could range from simple updates to your kitchen appliances, to completely changing the look of the entire house.
Once you've decided what sort of renovation you want to carry out, then you need to think about how much money you have available to spend. You may find that your funds are not sufficient to cover the whole project. This is a sign that you may not have enough funds to cover the entire cost of the project.
If you decide that you're going to go ahead and carry out renovations, then there are several things that you need to consider before starting work. The most important thing is to ensure that you get any permits required for the job. You should also check whether you require planning permission for certain types of work. For example, if you plan to add extensions to your home, you might need to apply for building consent.
Before you begin to renovate your house, make sure to check with the local authority to confirm that they do not require additional permits. Also, check whether you need planning permission for each part of the house that you intend to renovate. You might also need to check with your insurance provider if you are undertaking major work such as installing a roof.
Next, you will need to decide on the tools and materials that are best suited for your job. There are many different options available, so it's important to take your time to research them thoroughly. Most people use wallpaper paste, paint, flooring, tiles and carpets for their renovation projects.
It is important to evaluate the quality of these items when you are shopping for them. Good quality products will last longer and be more cost-effective. It is important to buy the right amount of anything when buying. It's important to not buy too much. You could waste valuable resources and end up with a lot of wasted material. Instead, make sure you only purchase what you really need.
Finally, once you've chosen the right materials for the job, you need to figure out where you'll store them while you're working on the property. If you're renovating a large area of the house, then you might need to rent storage space in order to keep all your supplies safe until you're ready to put them back inside the house. You can also ask family and friends to help move your items.